Revit MEP

Revit MEP

Reply
Valued Contributor
tim102289
Posts: 64
Registered: ‎04-15-2010
Message 1 of 2 (1,088 Views)

Revit could not find a matching Pipe Segment in Default pipe type

1088 Views, 1 Replies
09-20-2013 05:44 AM

Every time I try to start a pipe by clicking the connector on an air handler, I get the message:

 

"Revit could not find a matching Pipe Segment in Default pipe type. Please check the Default pipe type's routing preferences."

 

The connectors have a radius set to 1" so the pipe should come out 2".  When I click the connector however it always goes to 2 1/2" so I manually have to change it to 2".  And then once I click to place the segment of pipe, I get the message.  I've checked Segments and Sizes in the Routing Preferences and there is a 2" and 2 1/2" size both listed.  Any idea why I'm getting this error?

- Tim Smith
Motz Engineering

Revit MEP/AutoCAD/Sketchup
UC Architectural Engineering c/o 2016

"There is nothing more expensive than hiring cheap engineers." - Bob Sheeran, Xavier University 01/05/2005
*Expert Elite*
CADastrophe
Posts: 3,421
Registered: ‎08-28-2009
Message 2 of 2 (1,023 Views)

Re: Revit could not find a matching Pipe Segment in Default pipe type

09-23-2013 05:36 AM in reply to: tim102289

Under Mechanical Settings » Pipe Settings » Segments and Sizes, make sure that you're looking at the sizes for the proper Pipe Segment type - make sure the value of the "Segment:" pull-down matches listed under the desired Pipe Type's Routing Preferences. Each type of Segments has it's own Size Catalog.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.