Revit MEP

Revit MEP

Reply
New Member
1 Posts
0 Kudos
Registered: ‎10-03-2012
Post 1 of 2
Accepted Solution

Revit 2013 How to add a 2" insulation to the duct?

1008 Views, 1 Replies
10-03-2012 06:49 AM

Hello,

 

Please advise on how to cover the duct with 2" insulation.

 

Thank you.

It should be as simple as selecting the Duct or Duct Run (highlight a section of Duct and press 'Tab') and clicking the 'Add Insulation' tool located on the 'Modify" contextual tab. The following dialog box will prompt for thickness. See image below.

 

DuctInsulation.JPG

*Expert Elite*
3,478 Posts
997 Kudos
Registered: ‎08-28-2009
Post 2 of 2

Re: Revit 2013 How to add a 2" insulation to the duct?

10-04-2012 07:17 AM in reply to: omileyko

It should be as simple as selecting the Duct or Duct Run (highlight a section of Duct and press 'Tab') and clicking the 'Add Insulation' tool located on the 'Modify" contextual tab. The following dialog box will prompt for thickness. See image below.

 

DuctInsulation.JPG

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post