Revit MEP

Reply
New Member
omileyko
Posts: 1
Registered: ‎10-03-2012
Message 1 of 2 (785 Views)
Accepted Solution

Revit 2013 How to add a 2" insulation to the duct?

785 Views, 1 Replies
10-03-2012 06:49 AM

Hello,

 

Please advise on how to cover the duct with 2" insulation.

 

Thank you.

It should be as simple as selecting the Duct or Duct Run (highlight a section of Duct and press 'Tab') and clicking the 'Add Insulation' tool located on the 'Modify" contextual tab. The following dialog box will prompt for thickness. See image below.

 

DuctInsulation.JPG

*Expert Elite*
CADastrophe
Posts: 3,286
Registered: ‎08-28-2009
Message 2 of 2 (764 Views)

Re: Revit 2013 How to add a 2" insulation to the duct?

10-04-2012 07:17 AM in reply to: omileyko

It should be as simple as selecting the Duct or Duct Run (highlight a section of Duct and press 'Tab') and clicking the 'Add Insulation' tool located on the 'Modify" contextual tab. The following dialog box will prompt for thickness. See image below.

 

DuctInsulation.JPG

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.