Revit MEP

Revit MEP

Reply
New Member
omileyko
Posts: 1
Registered: ‎10-03-2012
Message 1 of 2 (992 Views)
Accepted Solution

Revit 2013 How to add a 2" insulation to the duct?

992 Views, 1 Replies
10-03-2012 06:49 AM

Hello,

 

Please advise on how to cover the duct with 2" insulation.

 

Thank you.

It should be as simple as selecting the Duct or Duct Run (highlight a section of Duct and press 'Tab') and clicking the 'Add Insulation' tool located on the 'Modify" contextual tab. The following dialog box will prompt for thickness. See image below.

 

DuctInsulation.JPG

*Expert Elite*
CADastrophe
Posts: 3,421
Registered: ‎08-28-2009
Message 2 of 2 (970 Views)

Re: Revit 2013 How to add a 2" insulation to the duct?

10-04-2012 07:17 AM in reply to: omileyko

It should be as simple as selecting the Duct or Duct Run (highlight a section of Duct and press 'Tab') and clicking the 'Add Insulation' tool located on the 'Modify" contextual tab. The following dialog box will prompt for thickness. See image below.

 

DuctInsulation.JPG

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.