Revit MEP

Reply
Active Member
Niamhy14
Posts: 7
Registered: ‎09-04-2012
Message 1 of 2 (319 Views)

Pipes showing turned down rather than up

319 Views, 1 Replies
01-15-2013 09:11 AM

Hello,
I am relativly new to Revit so bare with me.

 

I am having a problem with how my piping is showing. I am working on sanitary pipes that are underslab, with branches coming up through the slab to the lav/water closet/shower. When I turn the pipe up, it shows that the pipe is going down. I tried adjusting the view range/cut plane and can't seem to figure it out.

 

Any help would be greatly appreciated

 

Here is a sample of my issue:

asdfads.png

Distinguished Contributor
RKLindner
Posts: 134
Registered: ‎03-10-2004
Message 2 of 2 (314 Views)

Re: Pipes showing turned down rather than up

01-15-2013 09:37 AM in reply to: Niamhy14

Not sure if it meets your needs, but if you put a cap on the piping, it should show "circular" up rather than the down symbol.  The reason your picture looks like that has to do with the open end of the pipe and the cut plane I believe.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.