Revit MEP

Reply
Active Member
Niamhy14
Posts: 7
Registered: ‎09-04-2012
Message 1 of 2 (292 Views)

Pipes showing turned down rather than up

292 Views, 1 Replies
01-15-2013 09:11 AM

Hello,
I am relativly new to Revit so bare with me.

 

I am having a problem with how my piping is showing. I am working on sanitary pipes that are underslab, with branches coming up through the slab to the lav/water closet/shower. When I turn the pipe up, it shows that the pipe is going down. I tried adjusting the view range/cut plane and can't seem to figure it out.

 

Any help would be greatly appreciated

 

Here is a sample of my issue:

asdfads.png

Distinguished Contributor
RKLindner
Posts: 134
Registered: ‎03-10-2004
Message 2 of 2 (287 Views)

Re: Pipes showing turned down rather than up

01-15-2013 09:37 AM in reply to: Niamhy14

Not sure if it meets your needs, but if you put a cap on the piping, it should show "circular" up rather than the down symbol.  The reason your picture looks like that has to do with the open end of the pipe and the cut plane I believe.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.