Revit MEP

Reply
Valued Mentor
dennis
Posts: 707
Registered: ‎07-29-2005
Message 1 of 6 (508 Views)
Accepted Solution

Pipe System Flow Calc

508 Views, 5 Replies
01-03-2012 06:33 AM

I am getting FLOW for every pipe system, except Sanitary.  Is that something that isn't usually figured, or am I missing something?

Distinguished Mentor
asommer
Posts: 767
Registered: ‎08-10-2009
Message 2 of 6 (494 Views)

Re: Pipe System Flow Calc

01-03-2012 12:55 PM in reply to: dennis

There is something with that, I think it can size based on the connected loads, but not show flow in the System Browser.  I'm not exactly sure, but I know there is something with the Sanitary that doesn't work, so you are not the only one.  Maybe it is expected that there is NO equipment on the downstream end, although you may have a sewage pump sometimes.

 

On the same note, I had tried to "Finish" a Domestic Water System with a "Meter" to get the building Demand as calculated in the System Browser, and I could not get it to work.

Valued Mentor
dennis
Posts: 707
Registered: ‎07-29-2005
Message 3 of 6 (445 Views)

Re: Pipe System Flow Calc

01-09-2012 09:06 AM in reply to: asommer

I too found myself trying to close out a Cold Water System, and what I found was a family in the library: Mechanical Equipment / Pipe Connector - Domestic Cold Water - Plumbbing Equipment.  Load it, edit Family, set the connector to be "Calculated" and "Loss Method" as "Specified".  Hook it into a well connected cold system and it closed up the system giving me the overall flow value.  There is a similar family for the sanitary that i will check next.

Distinguished Mentor
asommer
Posts: 767
Registered: ‎08-10-2009
Message 4 of 6 (437 Views)

Re: Pipe System Flow Calc

01-09-2012 12:49 PM in reply to: dennis

Does that show up correctly in your "System Browser"?  I want to make a "Water Meter" out of this if it works.

Valued Mentor
dennis
Posts: 707
Registered: ‎07-29-2005
Message 5 of 6 (425 Views)

Re: Pipe System Flow Calc

01-10-2012 04:34 AM in reply to: asommer

I also found some PipeAssessories:Water Meter based on HERSEY METER at Revit City.  I had to tweek the connectors slightly, mainly matched up how the PipeConnector family previously mentioned was setup.  It closes up the Cold Water System to where there are no more 'warning triangles' when I use the "Check Pipe System'.  And yes, the System Browser appears correct to me.

Distinguished Mentor
asommer
Posts: 767
Registered: ‎08-10-2009
Message 6 of 6 (419 Views)

Re: Pipe System Flow Calc

01-10-2012 07:35 AM in reply to: dennis

Cool.  I will definitely look this up.  Thanks!

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.