Revit MEP

Revit MEP

Reply
*Expert Elite*
CADastrophe
Posts: 3,421
Registered: ‎08-28-2009
Message 11 of 12 (61 Views)

Re: Phasing and Designating families to be existing

01-21-2013 05:53 AM in reply to: kadmonkee8

kadmonkee8 wrote:

"i am unable to post images of the project due to privacy issues."


Understood. But know that without knowledge of the actual Phases in your Project, I can only attempt to provide some guidance.

 

You will have to do some chronological coordination. You can recreate all of the Phases from both project in your MEP model, but put them in proper order based upon when the that work will take place. If two of the Phases will be under way at the same time, then you can merge those Phases into a single Phase in your MEP Project. Then you will need to configure the Phase Mapping for each link as explained in post #5 in this thread.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Distinguished Contributor
kadmonkee8
Posts: 123
Registered: ‎11-01-2011
Message 12 of 12 (58 Views)

Re: Phasing and Designating families to be existing

01-21-2013 06:25 AM in reply to: CADastrophe

Thank you for your help

it has cleared up most of my questions and understanding of Phasing

I will check into the chronological coordination to verify all is good

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.