Revit MEP

Reply
New Member
cajackson
Posts: 1
Registered: ‎02-02-2011
Message 1 of 2 (255 Views)

Panel Schedule Problem

255 Views, 1 Replies
11-17-2011 01:12 PM

I have a 240/120V 3w-1P Panel PP4 feeding feeding another 240/120V 3w-1P Panel PP4A. In the the panel schedule for PP4 it shows the breaker feeding Panel PP4A as a single pole breaker and the load on Phase A but incorporates the Phase B loads in the the totals. How do I make the feeder breaker 2 Pole or do I have to do some creative thinking?

 

Thank you,

Chadwick

Distinguished Contributor
bcaudill
Posts: 131
Registered: ‎09-12-2008
Message 2 of 2 (241 Views)

Re: Panel Schedule Problem

11-18-2011 07:38 AM in reply to: cajackson

The number of poles is set in the connector of the element you're circuting, not the panel. Once you set the number of poles in the elements, the panel will read the 2-pole breaker.

 

HTH

~BMC

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.