Hi. I understand that Revit will not run a fixture unit count if any piece of piping is open, ie not connected to anything. How have people gotten around this problem with vent piping, and piping entering and leaving the building?
Solved! Go to Solution.
Solved! by abulla. See the answer in context.
Adding a cap is the easiest option.
Its my experience that if you change the SAN elbow into a tee then contiue drawing with Vent 'system' pipe, the fixture count is lost, even if the vent pipe is capped.
Has anybody found a solution or workaround to this?
The outside connection can remain open, as long as the rest of the system has no openings.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!