Revit MEP

Reply
Mentor
thombrady
Posts: 172
Registered: ‎07-21-2010
Message 1 of 3 (183 Views)
Accepted Solution

MEP Roof Plan

183 Views, 2 Replies
02-18-2014 05:20 AM

I want to show the HVAC Roof Equipment & I have low roofs so I have to adjust the View Range down. I figured if I had the roof plan & kept the roof box checked the only thing I would see below is roofing & anything above it. Unfortunately all the interior walls are showing up also. I know you are going to say shut off the walls, the problem is that the exterior walls also shut off & i am left with an empty shell. I have adjusted underlays, went from Plan to RCP & am running out of ideas. Again the issue is I want to look from above & see all the roofs & Equipment on those roofs & nothing else. thanks in advance

Have you tried creating a Plan Region for the lower roof areas?

*Expert Elite*
CADastrophe
Posts: 3,299
Registered: ‎08-28-2009
Message 2 of 3 (159 Views)

Re: MEP Roof Plan

02-18-2014 09:44 AM in reply to: thombrady

Have you tried creating a Plan Region for the lower roof areas?

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Mentor
thombrady
Posts: 172
Registered: ‎07-21-2010
Message 3 of 3 (151 Views)

Re: MEP Roof Plan

02-18-2014 10:29 AM in reply to: thombrady

Thank you, I used that before in 2012 & it did not wotk correctly or I was doing it wrong but that worked like a charm this time.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.