Revit MEP

Reply
Valued Contributor
AJVavruska
Posts: 54
Registered: ‎04-14-2006
Message 1 of 5 (777 Views)
Accepted Solution

Halftone existing pipe fittings

777 Views, 4 Replies
01-25-2012 02:44 PM

Revit MEP 2012

I am working on a remodel job that has existing piping. I halftoned the existing piping and fittings. The piping halftones but the fittings do not. The halftone is done in the Phasing dialog box. Any one have an idea how to halftone the fittings?

Thanks,

AJ

Some one in the office figured it out for me. The bottom primary range and the view depth level has to have the same offset.

Valued Contributor
AJVavruska
Posts: 54
Registered: ‎04-14-2006
Message 2 of 5 (775 Views)

Re: Halftone existing pipe fittings

01-25-2012 02:47 PM in reply to: AJVavruska

oh yea see the attached.

Valued Contributor
AJVavruska
Posts: 54
Registered: ‎04-14-2006
Message 3 of 5 (769 Views)

Re: Halftone existing pipe fittings

01-25-2012 03:38 PM in reply to: AJVavruska

Some one in the office figured it out for me. The bottom primary range and the view depth level has to have the same offset.

New Member
zbomb007
Posts: 1
Registered: ‎03-13-2009
Message 4 of 5 (676 Views)

Re: Halftone existing pipe fittings

02-21-2012 09:03 AM in reply to: AJVavruska

This worked, thanks

Member
jschmidt.allenshariff
Posts: 4
Registered: ‎08-13-2008
Message 5 of 5 (560 Views)

Re: Halftone existing pipe fittings

07-03-2012 06:10 AM in reply to: zbomb007

Yes, it fixes the fitting issues. However the beyond line style doesn't work and the below ground/slab piping doesn't show dashed if the view depths are set the same.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.