Revit MEP

Reply
Active Member
6 Posts
0 Kudos
Registered: ‎12-15-2012
Post 1 of 3

Flying Fittings

191 Views, 2 Replies
12-15-2012 01:51 AM

Has anyone faced a problem while working with a Revit MEP file, in which the fittings on a pipe or a duct just gets offsetted from the pipe and appears to be disconnected and in fact they are connected.

Valued Contributor
59 Posts
1 Kudo
Registered: ‎02-28-2008
Post 2 of 3

Re: Flying Fittings

12-18-2012 10:26 AM in reply to: ayman.ghomrawi

I used to see that in older versions of Revit and older hardware  Is your ram and video-card at or above the minimum spec? 

Active Member
6 Posts
0 Kudos
Registered: ‎12-15-2012
Post 3 of 3

Re: Flying Fittings (DarRef: Not Referenced)

01-15-2013 06:07 PM in reply to: RandMan
Hello, I have a 16 GB RAM and a Nvidia Quadro FX 1800 Regards ________________________________ Confidentiality & Disclaimer Note: This e-mail and any attachments thereto contain protected and confidential information intended for the sole use of the addressee individual or organization. If you are not the addressee or an authorized agent for him/it, or if you have received this message by error please notify the sender immediately by returning the message, and delete this copy from your system without any illegal use. The Dar Group shall not be liable for the improper or incomplete transmission of the information contained in this communication nor for any delay in its receipt or damage to your system.
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post