Revit MEP

Reply
Active Member
ayman.ghomrawi
Posts: 6
Registered: ‎12-15-2012
Message 1 of 3 (187 Views)

Flying Fittings

187 Views, 2 Replies
12-15-2012 01:51 AM

Has anyone faced a problem while working with a Revit MEP file, in which the fittings on a pipe or a duct just gets offsetted from the pipe and appears to be disconnected and in fact they are connected.

Valued Contributor
RandMan
Posts: 59
Registered: ‎02-28-2008
Message 2 of 3 (130 Views)

Re: Flying Fittings

12-18-2012 10:26 AM in reply to: ayman.ghomrawi

I used to see that in older versions of Revit and older hardware  Is your ram and video-card at or above the minimum spec? 

Active Member
ayman.ghomrawi
Posts: 6
Registered: ‎12-15-2012
Message 3 of 3 (82 Views)

Re: Flying Fittings (DarRef: Not Referenced)

01-15-2013 06:07 PM in reply to: RandMan
Hello, I have a 16 GB RAM and a Nvidia Quadro FX 1800 Regards ________________________________ Confidentiality & Disclaimer Note: This e-mail and any attachments thereto contain protected and confidential information intended for the sole use of the addressee individual or organization. If you are not the addressee or an authorized agent for him/it, or if you have received this message by error please notify the sender immediately by returning the message, and delete this copy from your system without any illegal use. The Dar Group shall not be liable for the improper or incomplete transmission of the information contained in this communication nor for any delay in its receipt or damage to your system.
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.