Revit MEP

Active Member
Posts: 10
Registered: ‎12-02-2004
Message 1 of 2 (204 Views)

Flows tracked through flex pipe?

204 Views, 1 Replies
10-01-2012 09:07 AM

Does Revit MEP track flows throught flex pipe?  I'm working on a project and have started to hook-up the hydronic unit heaters.  I thought I'd be able to flex from the mains but it doesnt' seem to be working.  If I "hard pipe" to the connectors on the unit, flow is transfer from the assigneed valve at the unit to the assocated piping network but not it the connection uses flex pipe.


Anyone else experience this, thoughts as to what I may be doing wrong?


Thanks in advance.

Posts: 1,299
Registered: ‎11-16-2005
Message 2 of 2 (171 Views)

Re: Flows tracked through flex pipe?

10-02-2012 07:56 AM in reply to: dworakma

Make sure your system is consistent throughout the 'network'... i.e., check each element's System Name... if they are different for any reason, this is indicates a discontinuous network, which will halt flow.


Refer to attached image... flow seems to work as expected through the flex.


Perhaps you can provide a simple model / exmple demonstrating the problem?

Martin Schmid, P.E.
Product Manager - Revit MEP
Architecture, Engineering, and Construction
Autodesk, Inc.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.