Revit MEP

Valued Contributor
Posts: 74
Registered: ‎10-30-2007
Message 1 of 2 (220 Views)
Accepted Solution

Flip sweep tee when placing

220 Views, 1 Replies
08-29-2013 02:10 PM

Is it possible to Flip the sweep tee before placing it on the pipe run? I see its going to be placed in the wrong direction but I can't Flip it to go in the opposite direction. Hitting the space bar only switches were the connecting point is, but wont Flip. 


Just wondering. 



*Expert Elite*
Posts: 3,230
Registered: ‎08-28-2009
Message 2 of 2 (165 Views)

Re: Flip sweep tee when placing

08-30-2013 12:35 PM in reply to: pverduzco

I haven't found a way to accomplish this. I was able to get that initial image of the Family (when hovering the cursor over the Pipe) to flip, but it doesn't effect the placement of the Pipe Fitting. I believe that placing and then flipping it afterward is the only way.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.