I created a plumbing fixture family with a shared parameter (ie, HWFU). When I set the connector to an Instance parameter, the fixture units calculate just fine.
I set the connector to a Type parameter, load the family into the project (overwrite existing & parameter values), change the Type parameter to a number (1 in this case), the calculated fixture units in the pipe drop to 0.
Any ideas on why this isn't working? I'm using Revit MEP 2013.
I just noticed that whatever I set the "default" value to before I load it into the project is what's calculated. Whenever I change the parameter, whether it be in the schedule or by Edit Type, it does not reflect in the pipe system.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!