Revit MEP

Reply
Active Member
DrewH09
Posts: 6
Registered: ‎09-27-2012
Message 1 of 2 (315 Views)

Fixture Units not calculating

315 Views, 1 Replies
09-27-2012 06:02 AM

I created a plumbing fixture family with a shared parameter (ie, HWFU).  When I set the connector to an Instance parameter, the fixture units calculate just fine.

 

I set the connector to a Type parameter, load the family into the project (overwrite existing & parameter values), change the Type parameter to a  number (1 in this case), the calculated fixture units in the pipe drop to 0.

 

Any ideas on why this isn't working?  I'm using Revit MEP 2013.

Active Member
DrewH09
Posts: 6
Registered: ‎09-27-2012
Message 2 of 2 (312 Views)

Re: Fixture Units not calculating

09-27-2012 06:09 AM in reply to: DrewH09

I just noticed that whatever I set the "default" value to before I load it into the project is what's calculated.  Whenever I change the parameter, whether it be in the schedule or by Edit Type, it does not reflect in the pipe system.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.