Thank you for the journal file.
The first thing I see is that Update 2 is not installed. I would download and install Update 2 from the page below:
Having said that, the issue is that the type definition of a shared parameter "Phase" does not match between the project file and family. I would verify the type definitions are the same.
Thank you for the update.
From the journal file, it does look to be the same issue. You'll need to delete the shared parameter from the family, and recreate it both the family and project file.
Having said that, if you are on Subscription, we may have additonal options.
I have tried to delete the parameter from the family, but I still get the same outcome when I try to load it. According to the journal file, it is still hanging up on the "phase" parameter even though I deleted it. Is there a way to remove a shared parameter from a family other than from the "family types" dialogue?
I believe I am having the same issue with a mismatched shared parameter "phase". I have attached my journal file, has there been a resolution to this? I've tried to remove all the parameters, but still seem to have the problem.
I also have a subscription, you mentioned there may be other options?
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!