Revit MEP

Posts: 12
Registered: ‎04-20-2011
Message 11 of 11 (114 Views)

Re: Electrical Family Constraint issue effecting elevation

05-13-2011 04:41 AM in reply to: RedMan77

That sounds about right.  There also seems to be a glitch in the programming when you switch between devices and changing the hosting option from Vertical Surface, Face, Work Plane hosted.  I've had this happen where devices have been placed correctly, then switched to a ceiling mounted device and changed it to Face hosted to place onto the ceiling then changed back to the receptacle to vertical surface hosting and it wouldn't show correctly - OR it would show correctly but the elevation would show 0'-0" even though it was at 4'-0".  Just another item to be wary about until it's fixed.



Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.