How can i move light fittings and power sockets etc that have been circuited (Wired) up without losing the circuit. For example we have a revised Architectural model but when we move the light fitting down to suit the new ceiling height we lose the circuit and tag for all the lights on that circuit.
Please see attachments (before & after) , Is Revit capable of this?
You shouldn't be losing the circuit connection just from moving the elements. Are you certain that the elements are actually being disconnected from the Electrical Circuit and not just losing their Tag? Also, what version of Revit are you running?
Welcome to the Autodesk forums, beanobt!
Feel free to post any questions you may have! There are many experienced users here who generously contribute their time and effort to supporting
their peers. This is an open, peer-supported forum, so feel free to contribute any useful information or experiences to any of the topics you see here.
We hope you'll stick around a while and help strengthen the value of this community!
Be sure to review the Ground Rules, visit the FAQ Forum, and use the Search feature prior to posting a question, as it's likely been asked before.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!