I have some families that I couldn't find the metric version of them and they are all imperial
what's the quickest way to make them metric?
I don't want to go to project units and change every single unit one by one in the family file and then load it to project
I've done some searching and I have not been successful in finding anything. For the most part, it shouldn't matter too much because the Family will be loaded correctly into a Metric Project anyway, regardless of the Family's Units settings because Revit uses its own internal values for length. If you still need to find a way to convert the Units en masse, then I suggest asking if this is possible on the Revit API board.
It is a real pain when I want to change the parameters value in my Revit model when they are all imperial and all my calculations are metric.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!