Revit MEP

Reply
Active Contributor
nh0mad
Posts: 41
Registered: ‎11-10-2009
Message 1 of 4 (1,295 Views)

Ductwork Hidden Lines

1295 Views, 3 Replies
01-14-2011 10:40 AM

New ductwork crossing at different offsets show the lower duct as a lighter lineweight and hidden linetype, which is od course what I want.

 Existing however is not showing as hidden. The offsets have plenty of space between. The lower duct has a break in the line where the ducts cross but the linetype stays the same and is a continuous line.  Any suggestions out there how to get it to look hidden?

 

Thanks!

 

Mark

Active Contributor
gladson_dialog
Posts: 32
Registered: ‎01-04-2011
Message 2 of 4 (1,249 Views)

Re: Ductwork Hidden Lines

01-19-2011 07:04 AM in reply to: nh0mad
Distinguished Mentor
asommer
Posts: 772
Registered: ‎08-10-2009
Message 3 of 4 (945 Views)

Re: Ductwork Hidden Lines

09-27-2012 02:46 PM in reply to: nh0mad

I am now having the same problem in 2012.  New ductwork works fine, but Existing Duct under New, and Existing Duct under Existing does not show as Hidden.  All my settings are correct, I cannot find a separate setting for Existing Hidden Lines, so what gives?  Please see my attached Pic.  The link above didn't help.

Distinguished Mentor
asommer
Posts: 772
Registered: ‎08-10-2009
Message 4 of 4 (941 Views)

Re: Ductwork Hidden Lines

09-27-2012 03:11 PM in reply to: nh0mad

I found it... The Graphic overrides for existing phase (in the Phasing dialog) patterns were overridden, showing solid.  I'm gonna find that gremlin and hurt 'em.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.