Revit MEP Forum
Welcome to Autodesk’s Revit MEP Forums. Share your knowledge, ask questions, and explore popular Revit MEP topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Ductwork Hidden Lines

3 REPLIES 3
Reply
Message 1 of 4
nh0mad
2360 Views, 3 Replies

Ductwork Hidden Lines

New ductwork crossing at different offsets show the lower duct as a lighter lineweight and hidden linetype, which is od course what I want.

 Existing however is not showing as hidden. The offsets have plenty of space between. The lower duct has a break in the line where the ducts cross but the linetype stays the same and is a continuous line.  Any suggestions out there how to get it to look hidden?

 

Thanks!

 

Mark

3 REPLIES 3
Message 2 of 4
gladson_dialog
in reply to: nh0mad
Message 3 of 4
asommer
in reply to: nh0mad

I am now having the same problem in 2012.  New ductwork works fine, but Existing Duct under New, and Existing Duct under Existing does not show as Hidden.  All my settings are correct, I cannot find a separate setting for Existing Hidden Lines, so what gives?  Please see my attached Pic.  The link above didn't help.

Message 4 of 4
asommer
in reply to: nh0mad

I found it... The Graphic overrides for existing phase (in the Phasing dialog) patterns were overridden, showing solid.  I'm gonna find that gremlin and hurt 'em.

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report