Revit MEP

Revit MEP

Reply
Contributor
manishsingh12jan
Posts: 15
Registered: ‎09-05-2012
Message 1 of 4 (984 Views)

Duct Creation Problem In offset Revit 2013

984 Views, 3 Replies
01-03-2013 01:35 AM

Dear,

 

 

I have a problem with revit Duct drawing through programme in C#.

 

Explanation: I draw a duct 24''*12'' with offset 0.0 to 50'' then i change offset 0.0 to 9.0 and then draw to 50'' and again i change offset to 0.0 . After that Drawn duct shows the size 24''*12'' but appearnce is not proper you can see in image. Please help me  if anyone has solution.

 

DuctHeight and Width Error.png

Active Contributor
nitinjambhale
Posts: 43
Registered: ‎04-21-2011
Message 2 of 4 (965 Views)

Re: Duct Creation Problem In offset Revit 2013

01-03-2013 01:47 AM in reply to: manishsingh12jan

Hi,

i think the problem is of Width, depth setting. Please check at once.

 

 

Active Member
DMallik
Posts: 7
Registered: ‎10-10-2012
Message 3 of 4 (962 Views)

Re: Duct Creation Problem In offset Revit 2013

01-03-2013 01:47 AM in reply to: manishsingh12jan

Hi All,

 

The question which asked my Manish, is good one, i am wondering for this answer.

 

Please reply any one, if you people already done.

Thankyou,
Mallikarjuna
Contributor
manishsingh12jan
Posts: 15
Registered: ‎09-05-2012
Message 4 of 4 (962 Views)

Re: Duct Creation Problem In offset Revit 2013

01-03-2013 01:48 AM in reply to: nitinjambhale

I set Hight and width correct. But looks same  as image above.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.