Revit MEP

Reply
Contributor
manishsingh12jan
Posts: 15
Registered: ‎09-05-2012
Message 1 of 4 (961 Views)

Duct Creation Problem In offset Revit 2013

961 Views, 3 Replies
01-03-2013 01:35 AM

Dear,

 

 

I have a problem with revit Duct drawing through programme in C#.

 

Explanation: I draw a duct 24''*12'' with offset 0.0 to 50'' then i change offset 0.0 to 9.0 and then draw to 50'' and again i change offset to 0.0 . After that Drawn duct shows the size 24''*12'' but appearnce is not proper you can see in image. Please help me  if anyone has solution.

 

DuctHeight and Width Error.png

Active Contributor
nitinjambhale
Posts: 43
Registered: ‎04-21-2011
Message 2 of 4 (942 Views)

Re: Duct Creation Problem In offset Revit 2013

01-03-2013 01:47 AM in reply to: manishsingh12jan

Hi,

i think the problem is of Width, depth setting. Please check at once.

 

 

Member
DMallik
Posts: 5
Registered: ‎10-10-2012
Message 3 of 4 (939 Views)

Re: Duct Creation Problem In offset Revit 2013

01-03-2013 01:47 AM in reply to: manishsingh12jan

Hi All,

 

The question which asked my Manish, is good one, i am wondering for this answer.

 

Please reply any one, if you people already done.

Thankyou,
Mallikarjuna
Contributor
manishsingh12jan
Posts: 15
Registered: ‎09-05-2012
Message 4 of 4 (939 Views)

Re: Duct Creation Problem In offset Revit 2013

01-03-2013 01:48 AM in reply to: nitinjambhale

I set Hight and width correct. But looks same  as image above.

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.