Revit MEP

Reply
Active Member
seanrafferty808
Posts: 9
Registered: ‎06-13-2012
Message 1 of 4 (252 Views)

creating parallel conduits with fittings

252 Views, 3 Replies
06-25-2012 07:14 AM

When I create a conduit line with bends and fittings, the parallel conduit is just straight and does not apply the fittings to the new parallel line.

 

Any help is appreciated!

 

Thanks

Valued Mentor
dennis
Posts: 751
Registered: ‎07-29-2005
Message 2 of 4 (247 Views)

Re: creating parallel conduits with fittings

06-25-2012 08:19 AM in reply to: seanrafferty808

Maybe it is the steps you need.  When you go to select the piece you want to offset, just highlight it and then hit the tab to walk down and get the the rest of the run, then select.

Active Member
seanrafferty808
Posts: 9
Registered: ‎06-13-2012
Message 3 of 4 (225 Views)

Re: creating parallel conduits with fittings

06-30-2012 05:38 AM in reply to: dennis
It doesn't create the parallel fittings though. I thought maybe somebody knew if there was just no way to create those bends and curves with parallel conduit.
*Expert Elite*
CADastrophe
Posts: 3,421
Registered: ‎08-28-2009
Message 4 of 4 (216 Views)

Re: creating parallel conduits with fittings

07-01-2012 08:28 PM in reply to: seanrafferty808

Could you post an image of you're situation? The steps dennis had described should produce parallel fittings under normal circumstances.

 

ParallelConduit.JPG

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.