Revit MEP

Reply
Active Contributor
sforsberg215
Posts: 36
Registered: ‎02-23-2011
Message 1 of 3 (201 Views)

Create Tags for No catagory

201 Views, 2 Replies
07-21-2011 06:43 AM

Hi!

 

I would like to create a plumbing riser tag. I am not sure what catagory to use or what type of tag I should use.

 

Any suggestions are welcome.

 

Thanks :smileyvery-happy:

*Expert Elite*
CADastrophe
Posts: 3,293
Registered: ‎08-28-2009
Message 2 of 3 (193 Views)

Re: Create Tags for No catagory

07-21-2011 07:36 AM in reply to: sforsberg215

What version of Revit are you using?

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Distinguished Mentor
Jrobker
Posts: 529
Registered: ‎09-29-2008
Message 3 of 3 (187 Views)

Re: Create Tags for No category

07-21-2011 09:53 AM in reply to: sforsberg215

sforsberg215 wrote:

Hi!

 

I would like to create a plumbing riser tag. I am not sure what category to use or what type of tag I should use.

 

Any suggestions are welcome.

 

Thanks :smileyvery-happy:


It depends on the category your going to tag. EVERYTHING is based off a category. If your going to tag a pipe riser, than you would use pipe tag. If you have a cap on the top you would use pipe accessory/fitting tag depending on what the family/system family is categorized under..Etc.

"It's hardware that makes a machine fast. It's software that makes a fast machine slow."

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.