Revit MEP

Reply
Contributor
chrissumner
Posts: 12
Registered: ‎04-11-2011
Message 1 of 3 (1,516 Views)
Accepted Solution

Change pipe line type with invert level

1516 Views, 2 Replies
07-30-2012 07:41 AM

Ive been told i can use filters to change a pipes linetype by invert level but cant figure out how it works. I'd like to set up a filter so pipes shown below the floor are hidden (below level 0), at low level (from level 0 to 2400) are solid and at high level(from 2400-slab) are a centre line. I know there's an overhead linetype but its too similar to the hidden.

 

Ive looked through the filters and cant see an option to filter by invert level?

 

Any help appreciated.

 

Thanks

 

I Chrissumer

 

i hope the images explain what you need to know. think its invert elevation your after.

 

Cheers

 

Guy

Active Contributor
gookeeper
Posts: 44
Registered: ‎02-09-2005
Message 2 of 3 (1,502 Views)

Re: Change pipe line type with invert level

07-31-2012 03:44 PM in reply to: chrissumner

I Chrissumer

 

i hope the images explain what you need to know. think its invert elevation your after.

 

Cheers

 

Guy

Contributor
chrissumner
Posts: 12
Registered: ‎04-11-2011
Message 3 of 3 (1,478 Views)

Re: Change pipe line type with invert level

08-01-2012 01:04 AM in reply to: gookeeper

 

Thankyou for taking the time to provide screenshots, the solutions works 100%

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.