I need to schedule cables running on a cable tray. My thoughts are to put parameters into the Cable tray family and filter the cable tray schedule on these parameters.
I was wondering if anybody else had a better way to do it.
Adding Shared Parameters to the Cable Tray system family would likely be the best solution, since Conduit and Cable Tray families contain no intelligence at this time.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!