Revit MEP

Reply
Valued Contributor
RJK42
Posts: 87
Registered: ‎04-04-2012
Message 1 of 2 (202 Views)

2D schematics and controls

202 Views, 1 Replies
10-05-2013 04:57 PM

I work as a mechanical designer.  Everyone in the design team I work in still uses AutoCAD for schematics and controls.  As I'm laying out my design, I normally set the detail to "Fine" so I can take full advantage of the realism.  When I set the detail to "Course" I notice some of the symbols revert back to the universal 2D representation.. i.e.. The the check valve.  When I click on the check valve and enter the family editor, I can't seem to find the 2D representation, only the 3D.  Where are the 2Ds?  I go in to the annotations folder then mechanical but only find a select few,  I would like to find the "Course" symbols so I can layout my schematics and controls all in Revit.  I'm trying to ultimately phase out AutoCAD.

 

Thanks

Active Contributor
jade6
Posts: 48
Registered: ‎06-09-2008
Message 2 of 2 (181 Views)

Re: 2D schematics and controls

10-06-2013 03:18 AM in reply to: RJK42

generally speaking, you could go to the plan view in the family editor to see some model lines for 2d representation.

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.