Revit MEP Wishes (Read Only)
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Element is reversed...No more

0 REPLIES 0
Reply
Message 1 of 1
joefields
417 Views, 0 Replies

Element is reversed...No more

One thing that would be really nice is when I have a pipe run that offsets up, let's say to go over a duct or other pipes, and I have to drop it below the other pipe that it wouldn't tell me the element is reversed and disconnect the pipe. Couldn't it see if it can flip the elbows and reconnect the pipe if it has room to make the connection. This would be really nice for coordination stuff as I am finding that I am having to raise and low my pipes to dodge ductwork and other pipes. I know that ductwork may need to do the same so it should be universal. Thanks
Joe Fields PE, LEED AP BD+C
Mechanical Engineer and C# Enthusiast
0 REPLIES 0

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report