Revit MEP Wishes

Reply
Valued Contributor
tkendrick
Posts: 82
Registered: ‎11-23-2011
Message 1 of 2 (286 Views)

Conduit Service Type

286 Views, 1 Replies
07-30-2012 08:57 AM

Once you apply a name to the Conduit Service Type, that name should continue on from the conduit. If you draw a section of conduit and end it, and continue it on that name should transfer to the new conduit you draw, I currently have to reselect the conduit network and re-type the servic type to apply it the entire run.

----
Use this link to tell Autodesk about features you need:
http://usa.autodesk.com/adsk/servlet/index?siteID=123112&id=1109794
*Expert Elite*
CADastrophe
Posts: 3,321
Registered: ‎08-28-2009
Message 2 of 2 (284 Views)

Re: Conduit Service Type

07-30-2012 09:30 AM in reply to: tkendrick

This simple issue helps to illustrate the poor level of intelligence of the Conduit Systems.

Corey D.                                                                                                                  ADSK_Logo_EE_2013.png    AutoCAD 2014 User  Revit 2014 User
──────────────────────────────────────────────────────────────────────
⁞|⁞ Please use Mark Solutions!.Accept as Solution and Give Kudos!Give Kudos as appropriate to further enhance these forums. Thank you!
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.