lasso loop arrow head style?

[Anonymous]

i have an annotative family for 3 phase Circuit Feeder tag

i would like to include a leader with a loop arrow head instead of the generic closed filled

can anyone recommend the steps needed

I'm lost with this one

thank you

[L.Maas]

Leaders do not have too much flexibility built in. However you can do a few things.

Inside the project select the tag family which you want to change. Then select Edit Type and choose a different arrowhead.

You have a small selection of different arrowheads. Until now (Revit 2015) you are not able to create your own arrowhead and are limited to the ones provided.

[abulla · Accepted solution]

There is a loop arrowhead, but you have to load it. Go to Manage -> Arrowheads and create a Loop style, pick the Loop arrowhead and the size, then you can use it in your project.

[Anonymous]

thank you.

that was exactly what i was looking for

[L.Maas]

Very good, you are right forgot to check over there.

[nsigrest_fiskcorp]

can you make the lasso loop end longer? currently if i use this loop. it only circles 1 conduit at a time. i would like to stretch it out to show multiple things being lassoed and are at the same elevation with one loop. thanks. 

[RobDraw]

You  can only change the size as mentioned in the solution but I wouldn't make this one bigger, though. I would make a copy of it and change the size of the copy.

[nsigrest_fiskcorp]

i don't need it bigger i need it longer. 

[RobDraw]

---

@nsigrest_fiskcorp wrote:

i don't need it bigger i need it longer. 

---

You can't do that with an arrowhead.

[nsigrest_fiskcorp]

Ok thanks for the feedback. 

[Anonymous]

So technically you do need to make it bigger so it picks up more pipes. What I did is I made it larger and when I place the tag I change it from attached to free then I can move the loop w/o affecting the text. Seems to work ok for us