Revit Architecture

Reply
Active Contributor
jmackniak
Posts: 33
Registered: ‎05-19-2011
Message 1 of 5 (729 Views)
Accepted Solution

Winder Stairs

729 Views, 4 Replies
01-14-2013 09:16 AM

i have looked through the discussion board and cannot find an answer to How to create a Winder staircase.

The as built staircase is a straight run with the first 3 or 4 treads winding.  I cannot figure out what my settings need to be etc. HELP!!

See that green horizontal line? That should be a riser (black line), not a boundary (green line). The boundaries areusually two sets of lines, on the sides of the stairs, not intersecting each other.

*Expert Elite*
Alfredo_Medina
Posts: 2,834
Registered: ‎06-11-2009
Message 2 of 5 (702 Views)

Re: Winder Stairs

01-14-2013 07:06 PM in reply to: jmackniak

There are, at least, 2 ways:

  • With the stair by sketch method, modify or create risers manually, with the Riser tool.
  • WIth the new stairs by component method, use the Winder tool.
-----------------------------------------------------------------------------------------------------------------
Planta1 Revit Online Consulting | info@planta1.com | my Twitter | The Planta1 Blog
Active Contributor
jmackniak
Posts: 33
Registered: ‎05-19-2011
Message 3 of 5 (685 Views)

Re: Winder Stairs

01-15-2013 05:34 AM in reply to: jmackniak

Al,  Thanks that is what i did.  I drew the stair boundry and placed the risers in. seemed to work fine. I get the error message below:  Stairs require no less than 2 boundries. (the MS paint image dropped some of the risers, trust me they are there)revit stairs.png

*Expert Elite*
Alfredo_Medina
Posts: 2,834
Registered: ‎06-11-2009
Message 4 of 5 (678 Views)

Re: Winder Stairs

01-15-2013 05:54 AM in reply to: jmackniak

See that green horizontal line? That should be a riser (black line), not a boundary (green line). The boundaries areusually two sets of lines, on the sides of the stairs, not intersecting each other.

-----------------------------------------------------------------------------------------------------------------
Planta1 Revit Online Consulting | info@planta1.com | my Twitter | The Planta1 Blog
Active Contributor
jmackniak
Posts: 33
Registered: ‎05-19-2011
Message 5 of 5 (647 Views)

Re: Winder Stairs

01-17-2013 09:11 AM in reply to: Alfredo_Medina

Why isnt this board (not sure what it is called) not running parallel with the stair case??revit stairs2.png

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Are You Going To Be @ AU 2014? Feel free to drop by our AU topic post and share your plans, plug a class that you're teaching, or simply check out who else from the community might be in attendance. Ohh and don't forgot to stop by the Autodesk Help | Learn | Collaborate booths in the Exhibit Hall and meet our community team if you get a chance!