Revit Architecture

Revit Architecture

Reply
Active Contributor
rlabib
Posts: 33
Registered: ‎12-14-2012
Message 1 of 3 (214 Views)

Wall sweep doesn't adjust automatically according to wall profile?

214 Views, 2 Replies
12-19-2012 11:38 AM

 

I just created a wall sweep on a wall , but I noticed the sweep doesn't adjust to the wall profile, please see the second floor wall in the attached image. Is there anyway to make the sweep adjust to the profile of the wall automatically?

 

 

 

South Elevation_Sweep_Problem.jpg

*Expert Elite*
LisaDrago
Posts: 1,373
Registered: ‎05-08-2009
Message 2 of 3 (172 Views)

Re: Wall sweep doesn't adjust automatically according to wall profile?

12-25-2012 06:28 AM in reply to: rlabib

You may want to consider a different tool for this... It looks like you want it to follow along the roof line.

You may want to try a roof fascia a try.

 

If this is not what you are looking for - may be little more info would help.

 

LD


If this helped solve your issue - remember to 'accept as solution' to help other find answers!
You can't think AutoCAD and run Revit.
Email: LisaDragoEE@gmail.com
Contributor
Intecinfocom
Posts: 18
Registered: ‎10-02-2012
Message 3 of 3 (145 Views)

Re: Wall sweep doesn't adjust automatically according to wall profile?

12-27-2012 03:58 AM in reply to: rlabib

you can also try to check 'lock' function

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.