Revit Architecture

Reply
Contributor
Jenb
Posts: 17
Registered: ‎12-05-2004
Message 1 of 2 (68 Views)

Wall profile

68 Views, 1 Replies
12-14-2004 01:11 PM
Is there a way that one can edit the profile of a wall in plan view? I often have angled walls joining with straight ones and Revit then joins them in a structured way while I would like to keep a corner on the one wall. I also have niches with angles sides and if I edit profile in elevation view Revit cuts these sides straight. Does someone know of a better way than to create a tiny extrusion or sweep?
*Aaron Rumple
Message 2 of 2 (68 Views)

Re: Wall profile

12-15-2004 08:37 AM in reply to: Jenb
For niches, I'd do a niche family for small niches. For larger ones I'd do 3 walls. The right side of the niche. The left side. Then the soffit wall above. This allows you to use the wall join tool with "square off" Or make an opening family using a generic wall hosted family. This will let you cut intricate voids in the wall. "Jenb" wrote in message news:7794888.1103058699247.JavaMail.jive@jiveforum1.autodesk.com... > Is there a way that one can edit the profile of a wall in plan view? I often have angled walls joining with straight ones and Revit then joins them in a structured way while I would like to keep a corner on the one wall. I also have niches with angles sides and if I edit profile in elevation view Revit cuts these sides straight. Does someone know of a better way than to create a tiny extrusion or sweep?
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.