Revit Architecture

Reply
Active Member
cadmansteve
Posts: 8
Registered: ‎10-02-2006
Message 1 of 2 (192 Views)

Trusses

192 Views, 1 Replies
12-03-2012 11:29 AM

I am laying out a simple structure. Bearing wall to bearing wall is 35’, with a few non bearing walls between the bearing walls. I will be using a truss to span from bearing wall to bearing wall.; Do I need to model the trusses or are their pre-made trusses with ¼”/1’-0” slope some were online.

*Expert Elite*
Alfredo_Medina
Posts: 2,865
Registered: ‎06-11-2009
Message 2 of 2 (179 Views)

Re: Trusses

12-03-2012 02:00 PM in reply to: cadmansteve

For the truss, you could start with a flat truss, such as a Pratt. Then do the sloped roof. Then select the truss and use "Attach top/bottom" "Top" and select the roof. The top of the truss will adquire the slope of the roof.

 

For the different type of wall above roof level, simply stop the lower wall at roof level, and use a different wall type above the roof.

-----------------------------------------------------------------------------------------------------------------
Planta1 Revit Online Consulting | info@planta1.com | my Twitter | The Planta1 Blog
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.