We have some Chinese clients with deep pockets who want curved glass and mullions, unfortunatly I can't figure it out in Revit. Seems like all the posts about curved glass give your response about cost and no solutions. If anyone can point me in the right direction it would be appreciated.
Actually, this is possible, especially if the curve is one direction only, like in a cylinder or similar. You need to create a curved panel, with a parameter that controls a point, which controls the curvature of the panel. You need to make some calculations to relate this parameter with the radius of the curtain wall.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!