Revit Architecture

Posts: 25
Registered: ‎05-15-2008
Message 1 of 2 (87 Views)


87 Views, 1 Replies
08-29-2012 08:40 PM

Is there a quick way of profiling topography under a undulating concrete floor slab? In other words so that the topography follows the underside surface of the slab. I know this is possible by adjusting each point on the topo surface but is there a quicker way?

Active Contributor
Posts: 38
Registered: ‎05-03-2011
Message 2 of 2 (81 Views)

Re: Topography

08-29-2012 09:07 PM in reply to: madone55

Create a pad.

Learn more about it by going into "Site & Massing" tab on the ribbon --> 'Building Pad' button.

- Sagar
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.