Revit Architecture

Posts: 25
Registered: ‎05-15-2008
Message 1 of 2 (85 Views)


85 Views, 1 Replies
08-29-2012 08:40 PM

Is there a quick way of profiling topography under a undulating concrete floor slab? In other words so that the topography follows the underside surface of the slab. I know this is possible by adjusting each point on the topo surface but is there a quicker way?

Active Contributor
Posts: 38
Registered: ‎05-03-2011
Message 2 of 2 (79 Views)

Re: Topography

08-29-2012 09:07 PM in reply to: madone55

Create a pad.

Learn more about it by going into "Site & Massing" tab on the ribbon --> 'Building Pad' button.

- Sagar
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.