Revit Architecture

Reply
Contributor
HomesByDundee
Posts: 16
Registered: ‎08-08-2012
Message 1 of 3 (218 Views)
Accepted Solution

Tags

218 Views, 2 Replies
03-18-2013 10:06 AM

Hello, I am trying to tag doors in a drawing. What I want to see is the door size, so I turn on 'width' parameter, and turn visibility off on the border of the text. Change the size of the text to match, easy enough. Now I want to place the text along the open door in the floor plan view, but the tag always jumps to the center of the door frame. Can this be modified to do as I want? is there an alignment parameter I can alter? Perhaps tagging the  door family and aligning it in the family editor? Please advise if Revit is capable of doing this. Until then, I have to place the text for each individual door.

The insertion point of the tag automatically comes in at the insertion point of the door. So the center of the tag comes in at the center of the door.

 

You can specify the origin of the tag to be different - but consider: will this move be appropriate for the majority of the tags? 

 

You will most likely have to move a few tags no matter what.

 

To change the origin - in the tag family select the middle reference planes and in the properties un-check Defines Origin. Make sure to place 2 new reference planes that Defines the origin - that the intersection of those planes is the point of origin.

 

LD

 

*Expert Elite*
LisaDrago
Posts: 1,374
Registered: ‎05-08-2009
Message 2 of 3 (192 Views)

Re: Tags

03-18-2013 12:17 PM in reply to: HomesByDundee

The insertion point of the tag automatically comes in at the insertion point of the door. So the center of the tag comes in at the center of the door.

 

You can specify the origin of the tag to be different - but consider: will this move be appropriate for the majority of the tags? 

 

You will most likely have to move a few tags no matter what.

 

To change the origin - in the tag family select the middle reference planes and in the properties un-check Defines Origin. Make sure to place 2 new reference planes that Defines the origin - that the intersection of those planes is the point of origin.

 

LD

 


If this helped solve your issue - remember to 'accept as solution' to help other find answers!
You can't think AutoCAD and run Revit.
Email: LisaDragoEE@gmail.com
Employee
loboarch
Posts: 984
Registered: ‎09-05-2003
Message 3 of 3 (185 Views)

Re: Tags

03-18-2013 12:52 PM in reply to: HomesByDundee

You can set a tag to come in vertical from the options bar.  Then you could use the move control on the tag to adjust the tag more toward the panel, or you could alter the origin of the tag as Lisa suggests.  Attached is a Revit file with tags that display the height and width.  The tag also include a spot for left of right hinge that pulls infor from the "comments" instance parameter.

 

door_tags.png 



Jeff Hanson
Sr. Subject Matter Expert
Autodesk, Revit User Experience
Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.