How can the dimensions for the system family door be shown in the door schedule?
I tried to make a instance paramater, type parameter, both through shared parameter for the doors in the family file, but they are still not showing up. Any suggestions please?
This question does not make sense. Doors are NOT system families, they are component families. A typical door family should have a height and width parameter which can be included in a schedule. When you create a door schedule width and height will show up in the fields selection of schedule creation.
Curtain wall doors do not have an explicit width and height parameter. A door in a curtain wall will inherit the size of the "cell" you are placing it into. It will report the cell size as height and width.
Access a broad range of knowledge to help get the most out of your products and services.
Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.
Upgrading to a 2015 product? Make sure to check these out 1st!