Revit Architecture

Revit Architecture

Reply
Distinguished Contributor
golf32902
Posts: 110
Registered: ‎12-01-2008
Message 1 of 5 (322 Views)
Accepted Solution

Standing Seam wall constuction

322 Views, 4 Replies
06-18-2013 08:07 AM

Ok, here is the problem that I am having.

 

I am trying to make a wall and I lay it out correctly but then an error pops up.

 

(Error: Row 3: Layer Function Priorities cannot ascend from the Core Boundary to the Finish Face)

 

Here is the construction of the wall.

 

1   Finish [4]                       Roofing, Standing Seam (aka standing seam wall panels)

2   Substrate [2]                 Plywood, Sheathing

3   Thermal /Air Layer [3]   Rigid insulation

4                 Core Boundary

5   Structure [1]                  Metal Stud

6                 Core Boundary

7   Finish [4]                       Gypsum Wall Board

 

 

There are a number of ways you can do it....but it has to be sequential and perform the way you want....

 

For example if the Rigid needs to have priority intersection it can be part of the Core Boundary and be assigned a 1 value....then you can have your plywood with a 2

 

Or you can change plywood to Finish 4 and the standing seam to Finish 5

Active Contributor
mpwuzhere
Posts: 36
Registered: ‎12-28-2006
Message 2 of 5 (315 Views)

Re: Standing Seam wall constuction

06-18-2013 08:57 AM in reply to: golf32902

The numbers have to go sequential to the outside....so you have to have 1,2,3,4....

 

So like the Error says, row 3 cannot happen as 1,3,2,4 is not in ascending order...

Distinguished Contributor
golf32902
Posts: 110
Registered: ‎12-01-2008
Message 3 of 5 (313 Views)

Re: Standing Seam wall constuction

06-18-2013 09:00 AM in reply to: mpwuzhere

I get that it needs to go 1 2 3 4, but the way it needs to be constructed is the way it is shown, is there a way to over-ride this setting and force it to show correctly as 1 3 2 4?

Active Contributor
mpwuzhere
Posts: 36
Registered: ‎12-28-2006
Message 4 of 5 (305 Views)

Re: Standing Seam wall constuction

06-18-2013 09:05 AM in reply to: golf32902

There are a number of ways you can do it....but it has to be sequential and perform the way you want....

 

For example if the Rigid needs to have priority intersection it can be part of the Core Boundary and be assigned a 1 value....then you can have your plywood with a 2

 

Or you can change plywood to Finish 4 and the standing seam to Finish 5

Distinguished Contributor
golf32902
Posts: 110
Registered: ‎12-01-2008
Message 5 of 5 (301 Views)

Re: Standing Seam wall constuction

06-18-2013 09:08 AM in reply to: mpwuzhere

I changed the Plywood and the Standing seam like you said, and it works like a charm. Thanks for the help.

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Announcements
Do you have 60 seconds to spare? The Autodesk Community Team is revamping our site ranking system and we want your feedback! Please click here to launch the 5 question survey. As always your input is greatly appreciated.