Revit Architecture

Reply
Mentor
haydenwse
Posts: 191
Registered: ‎10-24-2008
Message 1 of 6 (898 Views)

stair landing top & bottom

898 Views, 5 Replies
05-20-2013 03:02 PM

I can make a flight of stairs with a landing at the top but how do you make one that begins with a landing?  My stair structcure depth is 6", the rise is 7" and the landings are 8".  If I streching the first tread to make the landing it is only 7" (the height of the rise).  How do i make an 8" landing to begin a stair?

*Expert Elite*
constantin.stroescu
Posts: 1,018
Registered: ‎10-29-2008
Message 2 of 6 (866 Views)

Re: stair landing top & bottom

05-20-2013 11:36 PM in reply to: haydenwse

I am not sure I understood you well...is that what you want?

 

 

Image 1.png

Constantin Stroescu
BIM Manager AGD
Mentor
haydenwse
Posts: 191
Registered: ‎10-24-2008
Message 3 of 6 (840 Views)

Re: stair landing top & bottom

05-21-2013 08:09 AM in reply to: haydenwse

here is a screen shot of a work-around that i have come up with.  I bured an extra step at "riser depth below the landing elevation.  then I created a landing with a floor element.  it sort of works but I get a duplication of volume and the stair and landing concrete show up in different materilal scheduls.  it also makes the 3d views have a shadow step in the landing.

Active Contributor
Galimatías
Posts: 36
Registered: ‎10-09-2012
Message 4 of 6 (826 Views)

Re: stair landing top & bottom

05-21-2013 08:26 AM in reply to: constantin.stroescu

constantin.stroescu:

 

Hello,

 

How can i join the stair with the slab? Did you used a workaround?

 

Thanks

*Expert Elite*
constantin.stroescu
Posts: 1,018
Registered: ‎10-29-2008
Message 5 of 6 (802 Views)

Re: stair landing top & bottom

05-21-2013 10:08 AM in reply to: Galimatías

no workaround...

I worked on R 2014

Architecure >Stair>Stair by Component.

Work in section view. Select the stair. Geometry >Join. Stair concrete structure will join the core of the slab...

 

you can also edit Stair by Component in section view:

If in section view you select the stair and then : Edit > Edit Stairs > click again on stair and Drag the round blue point from upstair ( or downstair) the height of the stair will change but not the slope. Draging the arrow blue point will keep the height but change the slope...

 

 

Constantin Stroescu
BIM Manager AGD
Active Contributor
Galimatías
Posts: 36
Registered: ‎10-09-2012
Message 6 of 6 (765 Views)

Re: stair landing top & bottom

05-22-2013 10:32 AM in reply to: constantin.stroescu

constantin.stroescu:

 

Thank you very much.

 

 

 

 

 

 

 

Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.