Revit Architecture Forum
Welcome to Autodesk’s Revit Architecture Forums. Share your knowledge, ask questions, and explore popular Revit Architecture topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

Stair design

3 REPLIES 3
Reply
Message 1 of 4
kjskoog
209 Views, 3 Replies

Stair design

I am trying to figure out a way to design a stair that has 14 risers but the last 4 risers turn a total of 90 degrees. Any suggestions?

Kory Skoog
Kory Skoog
PM/BIM Manager
3 REPLIES 3
Message 2 of 4
sbrown
in reply to: kjskoog

If you mean an L shaped stair with a landing, you would just use 2 runs within the stair editor. If you need something more complex, just draw it out using the riser command, place all your risers where you want them, then draw the boundary lines. Note you want to start at the bot or the top as you draw them. If you post a sketch of the stair I maybe able to help better.
Message 3 of 4
kjskoog
in reply to: kjskoog

Here is the stair design I am trying to do. Saved in .dwg format. Thank you

Kory Skoog
Kory Skoog
PM/BIM Manager
Message 4 of 4
Anonymous
in reply to: kjskoog

Use Modeling>Stairs
Under the Stairs sketch Design Bar, use a combination of Boundary and Risers
to create the stair.
Boundaries are the sides of the stair.

Hope this helps.
David Haynes, AIA
Ideate, Inc.
www.ideateinc.com


wrote in message news:5067443@discussion.autodesk.com...
Here is the stair design I am trying to do. Saved in .dwg format. Thank you

Kory Skoog

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Rail Community


Autodesk Design & Make Report