Revit Architecture

Valued Contributor
89 Posts
8 Kudos
Registered: ‎04-03-2012
Post 1 of 2

Slab edge - Ramp

240 Views, 1 Replies
09-25-2012 04:47 AM

I am having a hard time figuring this out.


I have a slab that a building sits on - the slab becomes the sidewalk outside the building for 8'-0" of width and then it becomes a sloped ramp 4'-0" of width to the parking area - so there is no curb.  So, I cannot find out how to take a slab edge and slope id down from 4" thick to 0" thick over a 4'-0" width.


For clarification: the parking area ends 12'-0" from the face of the building - so you step out of the building, walk 8'-0" towards the parking area on flat slab and then you walk another 4'-0" towards the parking area on a sloped walk and then end up on the parking pavement.  The sidewalk is the full length of the building (roughly 25-0").


I looked into slab edge profiles but I cannot find one that subtracts instead of adds volume.  Is there a way to use massing to 'subtract' from the slab volume for this?


Any ideas out there?


Thanks - Dave.

*Expert Elite*
2,887 Posts
363 Kudos
Registered: ‎06-11-2009
Post 2 of 2

Re: Slab edge - Ramp

09-25-2012 05:45 AM in reply to: dtdesign

Do the portion that is flat as a floor, and the portion that is sloped as a ramp.

Planta1 Revit Online Consulting | | my Twitter | The Planta1 Blog
Post to the Community

Have questions about Autodesk products? Ask the community.

New Post