Revit Architecture

Reply
Contributor
sescadd
Posts: 17
Registered: ‎05-11-2012
Message 1 of 3 (329 Views)

Sheet view/ view port size

329 Views, 2 Replies
12-10-2012 11:28 AM

I am assembling my various views onto sheets.

My floor plan located in the sheet view has grips for what I assume is for the visible area desired in sheets.  I am not sure how or what I did to make these grips accessible.  I opened a new drawing and it does not seem to be in a default drawing.  When I open any of the other view foundation, roof, roof framing ect. I do not see the grips.

When in sheet view “floor plan” this area seems to have a box around it.  See attached drawing.

In the foundation view plan there are no grips and no box around it in the sheet view until you highlight it and I can not change sheet view.  See attached.

What I am trying do is fit the various views on to a sheet.  However they overlap each other. Question is how to change viewport size in sheet view so I can fit a number of different views onto one sheet.  How do I eliminate the box around the floor plan in sheet view? 

 

I guess I am use to the Autoarchitects view ports.  Perhaps it does not work that way in Rivit.

Active Contributor
tim.winnington
Posts: 37
Registered: ‎09-05-2012
Message 2 of 3 (302 Views)

Re: Sheet view/ view port size

12-10-2012 03:51 PM in reply to: sescadd

It looks like you have the viewport active.  I say this due to the title block being greyed out. 

The other reason I have found which causes the box around the view is if Crop Region Visible is selected.

Contributor
sescadd
Posts: 17
Registered: ‎05-11-2012
Message 3 of 3 (279 Views)

Re: Sheet view/ view port size

12-11-2012 03:56 PM in reply to: tim.winnington

Found it..........

Thanks

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.