Revit Architecture

Reply
Active Contributor
mthemelis
Posts: 34
Registered: ‎08-07-2004
Message 1 of 3 (161 Views)

section lines??

161 Views, 2 Replies
09-15-2004 02:41 PM
When i draw a section line it goes through the whole design.

is it possible to show only the section head and some cm of dashdot line and the same on the other side of the design?

because if you create a number of section views your drawing will be full of section lines.

thanks,
mike
Distinguished Contributor
sbrown
Posts: 1,185
Registered: ‎04-04-2002
Message 2 of 3 (161 Views)

Re: section lines??

09-15-2004 03:07 PM in reply to: mthemelis
You can pick on the section and you will see a break mark in the section line, click that and it splits the section line, then gives you grips to stretch the line as big or small as you wish.
you can also select multiple head/tail styles in the properties of the section line and create as many types as you want. You can also right click on any section line andsay hide annotation in view.
*Frame
Message 3 of 3 (161 Views)

Re: section lines??

09-16-2004 09:54 AM in reply to: mthemelis
Also, sections have a property "hide at views coarser than" which will keep the section from showing up in views with "coarse" scales. i.e. you may not want all your walls sections showing up in an 1/8" plan, but you do want your building sections to show up. "sdbrown" wrote in message news:10515684.1095286096176.JavaMail.jive@jiveforum1.autodesk.com... > You can pick on the section and you will see a break mark in the section line, click that and it splits the section line, then gives you grips to stretch the line as big or small as you wish. > you can also select multiple head/tail styles in the properties of the section line and create as many types as you want. You can also right click on any section line andsay hide annotation in view.
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.