Revit Architecture

Reply
Active Member
sconrad77
Posts: 9
Registered: ‎07-19-2010
Message 1 of 3 (535 Views)
Accepted Solution

Section Callout Annotation

535 Views, 2 Replies
05-14-2012 03:12 PM

Where is the setting to tell the section line to begin?  This line is cutting through our callout annotation circle, which happens to be sized larger than Revit’s default. See picture attached. Thanks for any help you can give. - StaceySection.png

That fixed it.  The thing that tricked me, is that I had to turn on the reference planes and move the callout and the reference planes.  Thanks so much for the help. -Stacey

Mentor
parveen.revit
Posts: 232
Registered: ‎09-29-2010
Message 2 of 3 (525 Views)

Re: Section Callout Annotation

05-14-2012 08:25 PM in reply to: sconrad77

modify your callout annotation circle family and move it to other side.

Parveen_Intec_Infocom (BIM, CAD, GIS, QS Services' Provider)
Active Member
sconrad77
Posts: 9
Registered: ‎07-19-2010
Message 3 of 3 (514 Views)

Re: Section Callout Annotation

05-15-2012 06:19 AM in reply to: parveen.revit

That fixed it.  The thing that tricked me, is that I had to turn on the reference planes and move the callout and the reference planes.  Thanks so much for the help. -Stacey

Post to the Community

Have questions about Autodesk products? Ask the community.

New Post
Need installation help?

Start with some of our most frequented solutions or visit the Installation and Licensing Forum to get help installing your software.